Waterpik® Water Flosser Model WF-03

Product Description: 

1. Power/pressure switch 2. Power handle 3. Battery door 4. Tip 5. Tip eject button 6. Flip top water inlet 7. Reservoir

Recommended Technique Lean low over sink and place the tip in mouth. Aim the tip toward teeth, and turn the unit ON (l). For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between teeth. Continue until you have cleaned the inside and outside of both the upper and lower teeth. Direct the jet stream at a 90-degree angle to your gumline. Slightly close lips to avoid splashing but allow water to flow freely from mouth into the sink. Keep unit upright during use for best results.

Adjusting the Pressure Setting You can adjust the pressure setting on your Water Flosser by simply sliding the pressure/power switch on the handle. Slide power switch up 1 click for low (l) pressure and 2 clicks for high (ll) pressure

Inserting and Removing Tips

Insert tip into the center of the knob at the top of the Water Flosser handle. The colored ring will be flush with the end of the knob if the tip is correctly locked into place. To remove the tip from the handle, press the tip eject button and pull tip from handle.

Filling the Reservoir

Lift the flip top on reservoir and fill the reservoir with lukewarm water.

When Finished

Turn the unit off. Empty any liquid left in the reservoir. If desired, the reservoir may be removed from the power handle by sliding the reservoir down towards the base of the unit. To replace the reservoir on the power handle, simply slide it up towards the top of the unit.